see, my requirement is to trigger a notification or order according to the value that is not in range of the counter. I have defined the below parameters...
counter upper value as 30 deg (in additional data tab).
counter lower value as 20 deg (in additional data tab).
counter annual reading as 1200
counter over reading value as 5000
now at the time of measuring documents via IK11 on
1-jan-2012 ...reading is...22 deg
2-jan-2012....reading is...28 deg
3-jan-2012....reading is...25 deg..
system is ok while putting value as 22 and then 28 . but at the time of putting 25 as a third entry, the difference and the total counter reading value in not coming properly. just test the scenario then only you can see the values.
please suggest me the process that how to trigger a notification or order when the measurement document reading is outside of the range of the measuring point.